Skip to main content

Thread: Left mouse button gone flakey

-

just upgraded 9.10 , went swimmingly now, couple of hours , reboot or 2 later, left mouse button has gone flakey. of time takes ten thirty seconds mouse-click holding left button down. other times takes longer , reacts normally. system's pretty close unusable appreciated.

sounds hardware failure happened coincidentally around same time ubuntu upgrade. let's verify or rule out:

how mouse work on 9.10 or 9.04 live cd?
or
how mouse work on different computers?
or
how other mice work on computer?

and
try different usb ports.

left mouse button used physical button on computer system. not surprising fail @ point, when think

if mouse indeed dying, suggest going local "mom , pop" computer store new one, , avoiding big corporate shops best buy have super mega deluxe mice $40 or more.


Forum The Ubuntu Forum Community Ubuntu Official Flavours Support Installation & Upgrades [ubuntu] Left mouse button gone flakey


Ubuntu

Comments

Post a Comment

Popular posts from this blog

Static ip - Raspberry Pi Forums

-
so having newest version of rasbian there isnt guids. in command propmt instructed sudo nano /etc/dhcp.conf first off should file empty lol?? because there's nothing in mine. im using eth0 & need commands/ enter /etc/dhcp cd .conf append along lines of code: select all interface eth0 static ip_address=192.168.0.10/24 static routers=192.168.0.1 static domain_name_servers=192.168.0.1 8.8.8.8 raspberrypi
Read more

arduino bug sur secteur, batterie, mais pas en usb?

-
bonjour, je travaille sur un premier projet de barrière infrarouge pour photographier les oiseaux, https://www.youtube.com/watch?v=8xzqd9iefgy&feature=youtu.be quand je suis alimenter en usb tout va bien, mais lorsque je passe par une alimentation extérieur (9v 12v secteur 12v) plus rien ne marche, la led clignote, les relais basculent n'importe comment. il me semble que se sont les capteurs qui bugs...(pas assez de courant?) 2 capteur ir = 2x100ma 2 relais = 2x40ma 1 diode, 1 push buttom la carte elle même... on est environ à 400ma. je ne comprends pas pourquoi ça coince!   le régulateur de la carte est prévu pour alimenter la carte et quelques petits accessoires pas trop gourments en courant. si on lui en demande trop il chauffe et la tension délivrée s'effondre. l'usb est, elle, prévue pour délivrer jusqu'à 500 ma. avec tous les ma consommés il faut une alim 5v supplémentaire. alim 5v +/- 5%, avec le 0v relié à celui de la carte...
Read more

What voltage is sent to the arduino GND when a transistor is used

-
Image
hi i learning transistor circuits following sources: http://www.instructables.com/id/use-arduino-with-tip120-transistor-to-control-moto/ https://itp.nyu.edu/physcomp/labs/motors-and-transistors/using-a-transistor-to-control-high-current-loads-with-an-arduino/ https://learn.adafruit.com/adafruit-arduino-lesson-13-dc-motors/transistors in 3 of examples emitter connected arduino gnd , wondering how current/ voltage sent arduino gnd pin? thanks in advance quote i wondering how current/ voltage sent arduino gnd pin? all of (current) Arduino Forum > Using Arduino > General Electronics > What voltage is sent to the arduino GND when a transistor is used arduino
Read more